Bucket tooth pin removal tool manufacturer introduces the replacement of the tooth

　　The excavator tooth is an important consumable part on the excavator. Similar to a human tooth, it is a combination of a tooth holder and a tooth tip. The two are connected by a pin. Since the tooth wear failure portion is the tooth tip, it is only necessary to change the tip. But this part of the parts and other parts are actually the same, need to be disassembled, then bucket tooth pin removal tool is very important.

　　Bucket tooth pin removal tool manufacturer tells you the classification according to the environment in which the excavator teeth are used. Excavator tooth can be divided into rock tooth, earth tooth (, tapered tooth. According to the tooth seat: the excavator tooth can be divided into vertical pin tooth (Hitachi excavator mainly), cross pin tooth, Rotate the teeth and keep the teeth sharp. The teeth on both sides of the bucket are generally faster than the teeth in the middle of the bucket. When the teeth on both sides wear much shorter than the middle teeth, you can The position of the tooth on both sides is interchanged and continues to be used. If the difference between the tooth at the center and the length of the tooth at both ends is 2 to 3 cm, it should be exchanged.

　　Bucket tooth pin removal tool manufacturer's introduction If the difference between the tooth at the center and the length of the tooth at both ends is 2 to 3 cm, it should be exchanged. Please replace the teeth in time. Visually check the looseness and wear of the bucket teeth before daily work. If the bucket tooth wear exceeds the use limit, it will not only damage the tooth holder and the bucket, but also affect the efficiency of the excavation and reduce the output.